COLOR-CHANGING LED
POOL/BATHTUB LIGHT


Color-Changing LED Pool/Bathtub Light, retail $9.98 (www.harrietcarter.com...)
Manufactured by (Unknown)
Last updated 06-27-07




This is a disc-shaped light meant to be used in swimming pools, bathtubs, koi ponds, and other water areas with a smooth side at the surface of the water. I say "with a smooth side" because the suction cup on the back requires a smooth surface to adhere properly. But it does float if the suction cup fails, so it can be easily fished out of the water and stuck back where you had it.

It has five (5) LEDs in it: one each white, red, amber, green, and blue. You can set it to do a "color wash" with the four colored LEDs, set the white LED to slowly fade on and back off, and CRYSTAL FREEZE...er...uh..."freeze" (O crap!!! There I go thinking about the TV program Digimon again) the display at any color of the colored LEDs or brightness of the white LED.


SIZE



Feed it first (see directly below), and then you can light up that pool, bathtub, sink, toilet tank, spa, hot tub (with smooth plastic walls inside, not wooden ones), wall-mounted porcelain uranator, etc.

Press the center button until it clicks and then release it to turn the unit on.
Do the same thing again to turn it off.

With the unit on, press the leftmost button until it clicks and then release it one or more times to change modes as follows:
  1. White LED - fades up and down slowly
  2. Color wash: blue, amber, green
  3. Color wash: green, red, amber
  4. Color wash: amber, blue, red
  5. Color wash: red, green, blue
To "freeze" the unit at any color of the colored LEDs or brightness of the white LED, press & release the rightmost button.



To change the batteries in this unit, turn the unit upside-down, rest it in your palm, use your other hand to turn the base clockwise (as though tightening it) approximately 1/12th of a turn, lift it off (turn it *FIRMLY* if necessary; it may be on there fairly tightly), and set it aside.

Inside the unit, you'll see a rectangular battery door with a clip on each side. Press in on these clips, lift the battery door off, gently place it on the ground, and kick it into the garden so the hungry, hungry praying mantids will think it's something yummy to eat and subsequently strike at it...O WAIT!!! YOU'LL NEED THAT!!! So just set it aside instead.

If necessary, remove and dispose of or recycle the 4 AA cells as you see fit.

Insert four new AA cells, orienting each one so its flat end (-) negative faces the spring for it in each chamber.

Place the battery door back over the opening, and gently press in on it until it clicks.

Place the circular base back on, and rotate it until it snaps into place. Press down firmly while turning it counterclockwise (as though loosening it) approximately 1/12th of a turn until it stops turning (turn it firmly to be certain it's all the way on there to help ensure water-resistance); and there, you're finished.
Aren't you glad you didn't kick that battery door into the garden with all those hungry, hungry praying mantids now?


Here is what a praying mantis looks like.
I found this guy on the morning of 09-08-06 clinging to the basket of my scooter.



This product is meant to be used as a decorative light in a pool or bathtub, not as a flashlight meant to be carried around, thrashed, and abused. So I won't throw it against the wall, stomp on it, run over it, swing it against the concrete floor of a patio, bash it open to check it for candiosity, fire it from the cannonada (I guess I've been watching the TV program "Viva Piņata" too much again - candiosity is usually checked with a laser-type device on a platform with a large readout or with a handheld wand that Langston Licktoad uses), send it to the Daystrom Institute for additional analysis, or inflict upon it punishments that a regular flashlight might have to have performed on it. So this section of the web page will be significantly more bare than this section of the web page on a page about a flashlight.

The product is waterproof and even submersible to short depths too - not at all surprising since it was specifically meant to be used in and around water.



Photograph of the product, illuminurinated...er...uh...ILLUMINATED of course.



Photograph of the product bobbing around in (floating in) a cistern (toylet tank).
This product was meant to be used in water, so showing it in water is appropriate here.



Photograph of the product fastened to the inside of a sink; bathroom lights on.



Photograph of the product fastened to the inside of a sink; bathroom lights off.

WMP movie (.avi extension) showing the product color-cycling.
This clip is approximately 3.7 megabytes (3,996,244 bytes) in length; dial-up users please be aware.
It will take no less than fifteen minutes to load at 48.0Kbps.
I cannot provide it in other formats, so please do not ask.

That music you might hear is from a demo I wrote for the Commodore 64 computer in 1992.
The demo's actual filename is a toliet word, so I cannot say it here. It starts with "PU" and ends with "ED".
Think of a kitty cat being flogged with a long flexible instrument used for administering a beating and you can probably figure it out.



TEST NOTES:
Test unit was ordered on 06-15-07, and was received on the afternoon of 06-26-07.

Product was made in China.
A product's country of origin really does matter to some people, which is why I published it on this web page.


UPDATE: 00-00-00



PROS:



CONS:



    MANUFACTURER: Unknown
    PRODUCT TYPE: LED bathtub/swimming pool light
    LAMP TYPE: LED
    No. OF LAMPS: 5 (1 ea. white, red, amber, green, blue)
    BEAM TYPE: N/A
    SWITCH TYPE: Pushbuttons for on/off/mode change/color freeze on top of unit
    CASE MATERIAL: Plastic
    BEZEL: N/A
    BATTERY: 4xAA cells
    CURRENT CONSUMPTION: Unknown/unable to measure
    WATER RESISTANT: Yes
    SUBMERSIBLE: Yes, to shallow depths at minimum
    ACCESSORIES: None
    WARRANTY: Unknown/not stated

    PRODUCT RATING:

    Star Rating





Color-Changing LED Pool/Bathtub Light * www.harrietcarter.com...






Do you manufacture or sell an LED flashlight, task light, utility light, or module of some kind? Want to see it tested by a real person, under real working conditions? Do you then want to see how your light did? If you have a sample available for this type of real-world, real-time testing, please contact me at bdf1111@yahoo.com.

Please visit this web page for contact information.

Unsolicited flashlights, LEDs, and other products appearing in the mail are welcome, and it will automatically be assumed that you sent it in order to have it tested and evaluated for this site.
Be sure to include contact info or your company website's URL so visitors here will know where to purchase your product.


WHITE 5500-6500K InGaN+phosphor 
ULTRAVIOLET 370-390nm GaN 
BLUE 430nm GaN+SiC
BLUE 450 and 473nm InGaN
BLUE Silicon Carbide
TURQUOISE 495-505nm InGaN
GREEN 525nm InGaN 
YELLOW-GREEN 555-575mn GaAsP & related
YELLOW 585-595nm
AMBER 595-605nm
ORANGE 605-620nm
ORANGISH-RED 620-635nm
RED 640-700nm
INFRARED 700-1300nm
True RGB Full Color LED
Spider (Pirrahna) LEDs
SMD LEDs
True violet (400-418nm) LEDs
Agilent Barracuda & Prometheus LEDs
Oddball & Miscellaneous LEDs
Programmable RGB LED modules / fixtures
Where to buy these LEDs 
Links to other LED-related websites
The World's First Virtual LED Museum
Legal horse puckey, etc.
RETURN TO OPENING/MAIN PAGE
LEDSaurus (on-site LED Mini Mart)



This page is a frame from a website.
If you arrived on this page through an outside link,you can get the "full meal deal" by clicking here.